And this video, you will learn how to use the clopping it's commonly used in steel structures such
as Pearlman's, and it sometimes be required in concrete structures.
First, I will arrange my windows vertically to have a clearer view.
And this example, I will draw steel columns with the default settings for the internal columns.
It will be from base level to second level, and for the external columns it will be from base level
to first level.
And so we will have beams, which is not horizontal, and we can draw it in 3D view.
Also, we can create a sloped plane from all of that in the level group to slow plane and then specify
three points in this plane and now it's been created.
And now you can see it in the structure window, you can open it by double click on it.
I will keep the sloped plane and the three the Plainview opened to see the drone ornaments, I will
draw the main beams and the sloped plane.
Then to model the Pearlman's go to Ed, great influence.
This command allows you to draw a quick pattern of beams inside a closed region.
I will choose your MP two hundred, for example.
You can draw Infeld's using either spacing or number of maximum spacing.
And, sir, the desired by you and move the cursor onto that closed vision.
Notice how the orientation of the NFL depends on the new age and the small example, I will choose eight
and four themes.
And you cannot and the 3D view, how it's done in a very efficient way.
And this steel structure, don't forget to change the time of the floor to tell us, which means the
steel.
Now we will learn how to use the medicament and the three, did you apply the top you.
Select all the power lines.
I will select also the beams and the main beams to be mirrored.
Now from Ed Choo's middle command to duplicate these elements to the other side, notice that I'm using
a type of metal thick metal plane which needs to select two opposite points to apply the metal command.
And the same way I would create a new slobby by selecting three points.
It by DoubleClick to draw the main beams.
I will choose be from all of that and the properties window, I will choose the same section IPB 400.
And I will create in the same procedure as previous.
I will select the created unfurls using the control key to select multiple, make sure to select the
right elements.
And using the middle command to placate them to the other side, now, we still need to draw the top
and the.
This was a quick video to learn how to use the sloped plane and the middle command, but it will be
in more details in the next sequence.