And this video, you will learn how to throw slap on beams, but first I will rename the levels more
allegedly.
Now, from model to choose concrete beams, you could recommend to choose a concrete glass for vertical
elements, which is higher than the concrete glass for vertical elements based on capacity design roll
in order to prevent the soft stalling mechanism.
Thus, I will use C twenty five, thirty four slabs and beams and I've already used C thirty thirty
seven for columns and walls.
Plastic hinges must be occur on the horizontal elements and never occur in their vertical elements.
I will choose 250 by five tips for the perimeter beams and keep the default settings for other preferences,
drawing beams and easily use and using start point and second point, you can press escape to undo the
selected points and press enter to finish the beat.
You may notice that Tekla gives help and points on any linear element midpoint, third point and quarter
point.
You can also see the auto alignment works perfectly.
You can also draw beams using rectangular and this command draws the beams between selected columns.
You can notice that auto alignment doesn't work for these elements and it needs to be modified manually,
choose the beam and the properties window, scroll down so you will see the spans of this element in
the desired span and enter the accurate alignment for it.
Do the same full beams that needs to be modified.
And now the perimeter beams are ready.
I will define new section for the internal beams and make sure to choose the concrete glass see twenty
five thirty.
I will keep the design active for all the elements.
And the section is 250 by six hundred millimetre square.
You can see how the consider the existing of the core and break the beams which Collini to it.
Now, after I finish the beams out, choose on beams from muddled up.
I will define a new slab.
You can draw the slab on beams either by selecting the base or by selecting the corners of the slab.
There are many properties that you may modify.
You can specify the reinforcement, the type of the reinforcement, the size and the distance in case
you want to disable the design.
Also, you can choose one way or two ways that I would choose the over 180 millimeters and the concrete
blast, see twenty five thirty.
And selecting the base, I will draw the slab on Vimes.
The two arrows on each slab represent the low distribution way, and I'm choosing to wage on beams.
Bear in mind that and content and the right hand of the screen, you can show or hide any element,
you may choose to hide the slabs in case you want to facilitate the selection of beams.
And if you can see the same content, you can go to windows and show it.
Now, I will define the ground floor as similar to the roof.
This will replicate all elements directly and easily from one story to another.
And this is the end of this video.
And the other slabs will be in the next videos.