In this video, I will design the first lap, but before the design, I will draw the colored patches
which generally have more extra reinforcement.
So I will go to the plan view and from design tab.
Perche Cullum's.
You may draw a patch for each column, but in this example I will draw a patch panel which cover the
Collina columns and to draw my panels I need construction lines to help me specify the center of each
panels.
So from model tab, go to construction lines.
I would choose parallel quick
and I will specify the offset length to be in the center.
I also drew the dimension of the slab to specify the length of the panels from model type dimensions,
and now I can draw the panels and you can see in the properties window, I can specify at centroid of
the slab, which I'm not interested in this example because I want to do it as Línea above the columns.
So I will specify the length and the width of each panel.
And I will use the center point, and that's why I draw the construction lines in the centers to help
me specify this point, and now I do all the panels on X direction and on Y direction.
Now, choose the Y direction and specify the consider steps for this panel from the properties window.
Also, you can choose to combine that reinforcement with the reinforcement of the slab or make it separate,
I will combine it for now and I will choose the reinforcement only for the Y direction.
If you want to design it manually, of course, you can modify the reinforcement, choose the type and
the size bar and the concrete cover, and I will do the same for the X Direction panel.
And bear in mind that automatically design, you have to choose that diameter of the vase from the design
settings.
Now, I will design the slap from design to design Snapp's.
And you can see that slab has passed, but the panels are unknown because they haven't designed yet.
I will check the reinforcements and leave you to slap law enforcement, and you can see for the bottom
X direction, it's 10 millimeter with 150 spacing and from the properties window, you can change the
top and the Y direction, the extraction.
Now, I will design the panels from these untap.
And you can see that some of them have failed.
So if we go to review their reinforcement and from the properties window and change the type from mesh
to patches, you can review the reinforcement of the patches.
Here you can notice that there is a patch that's drawn by mistake and most likely that I double click
on the patch when I was drawing.
So I draw two panels in the same position, one of them now working on the Y direction and the other
works on the both directions.
So it needs to be deleted.
However, I will check the failure and the patches.
If you can't select the patches easily, you can hide the slope from the scene content and now you can
check the slab design.
And now I will follow that X mark to see where is the failure.
Also, you can go to the results fuel to check that reinforcement, GraphicLy.
This is the required reinforcement for the stop, for example.
You can see that patches are working perfectly and the and the concentrating area.
Now, if I show the bottom, I see a high value of acquired reinforcement in this circles, so I think
it's the reason of the failure.
So a possible solution that I drew parameter beams around the slab and I will redesign again to check
if it's passed or not.